DYNA® DYNABOND 400

DYNA® DYNABOND 400 | Thin-Set Mortar (for Floor & Wall Tiles) (Premium Grade) is a Portland cement powder, graded silica aggregates and chemicals carefully selected and controlled by DYNA Corporation. It is a resin-reinforced high shear bond strength dry-set thin-set mortar. It provides a permanent installation with high bond strength and requires no soaking of tiles. DYNABOND 400 is resistant to water after being cured but does not provide a waterproof barrier.

Areas with prolonged contact with water, DYNALASTIC 5000 should be used in place of water when mixing. When mixed with DYNALASTIC 5000 it may be installed for indoor residential and light to moderate commercial floors and countertops in dry areas only over CSA-0211 EXTERIOR SELECT or (SEL TF) Douglas Fir plywood according to COFI classification, vinyl asbestos tile and dry cut-back adhesive. For increased freeze/thaw resistance mix with DYNALASTIC 5000 in place of water. For the installation of porcelain stoneware tile DYNALASTIC 5000 should be used in place of water.

ADVANTAGES

– Easy to Handle: Plastic, workable, glides on, non-sagging, long open time and increased tile adjustability.
– High Bond Strength: Greater than 200% stronger than mastic type adhesives.
– Versatile: Lower material and labour costs than conventional Portland cement mortar beds.

USES

Ideal for setting absorptive, semi-vitreous and vitreous ceramic, marble, and granite floor and wall tiles over concrete masonry, cured Portland cement mortar beds, brick, glass mesh mortar units, gypsum board, unglazed ceramic, marble and clay tile for residential, commercial, interior or exterior applications.

COLORS

LIMITATIONS

1. Stone such as Rosso Levanto and Negro Marquina or any green marble can be set with this material but due to the characteristics of these types of stone, warpage may occur due to changes in temperature, humidity, or the water in the thin-set mortar. It is, therefore, recommended that DYNAPOXY be used for the setting of these stones.
2. For the installation of white or translucent marble a white setting mortar should be used.
Do not use grey mortar mixes as this may discolour or stain the stone.
3. Do not use over presswood, particle board, Masonite, chipboard, laun, asbestos board, gypsum floor patching compounds, metal glass, plastic or any unstable materials which are deemed unsuitable substrates.
4. In dry areas only for interior residential, light or moderate commercial floors when mixed with DYNALASTIC 5000 in place of water it can be used on CSA-0211 Exterior Select or (SEL TF) Douglas fir plywood and countertops.
5. Do not use in temperatures below 10°C (50°F) or above 40°C (104°F).
6. Keep the area of installation from freezing for at least 28 days after application.