DYNA® AEROFLEX 670

DYNA® AEROFLEX 670 is a premium multi-purpose lightweight polymer modified Portland cement mortar. It can be used in thin and medium bed applications. It provides high sag and slip resistance. Provides twice the coverage compared to traditional thin-set mortars.

USES

– For interior setting of non-vitreous, semi-vitreous and vitreous ceramic tiles, marble, granite, quarry tiles, pavers, slate, dimensional natural stone, and porcelain stoneware tile.
– For interior and exterior setting of semi-vitreous, and vitreous floor and wall tile applications.
– Tiles can be set over concrete masonry, cured Portland cement mortar beds, glass mesh mortar units, gypsum board, unglazed ceramic tile, marble, clay tile, prepared existing cementitious terrazzo floors and cementitious backer unit for residential and commercial applications.
– For interior installation of porcelain tiles over most well-prepared stable substrates provided the tiles are smaller than 30 x 30 cm (12” x 12”).
– May be used on larger tiles but more cure time is required.
– It may be used for installation for indoor residential and light to moderate commercial floors and countertops in dry areas only over CSA-0211 EXTERIOR SELECT or (SEL TF) Douglas Fir plywood according to COFI classification, vinyl asbestos tile and dry cut-back adhesive.

LIMITATIONS

1. Stone such as Rosso Levanto and Negro Marquina or any green marble can be set with this material but due to the characteristics of these types of stone, warpage may occur due to changes in temperature, humidity, or the water in the thin-set mortar. It is, therefore, recommended that DYNAPOXY 6100 be used for the setting of these stones.
2. For the installation of white or translucent marble a white setting mortar should be used.
Do not use gray mortar mixes as this may discolor or stain the stone.
3. Do not use over presswood, particle board, Masonite, chipboard, lauan, asbestos board, gypsum floor patching compounds, metal, glass, plastic or any unstable materials which are deemed unsuitable substrates.
4. Do not apply in temperatures below 10°C (50°F) or above 40°C (104°F).
5. Keep the area of installation from freezing for at least 28 days after application.