DYNA® DYNAFLOR 300

DYNA® DYNAFLOR 300 | Thin-Set Mortar (for Non-Absorptive Floor Tiles) is a Portland cement powder, graded silica aggregates and chemicals carefully selected and controlled by DYNA Corporation. It is a high shear bond strength dry-set thin-set mortar. DYNAFLOR 300 provides a permanent installation with high bond strength and requires no soaking of tiles. DYNAFLOR 300 is resistant to water after being cured but does not provide a waterproof barrier. Areas with prolonged contact with water, DYNALASTIC 5000 should be used in place of water when mixing. When mixed with DYNALASTIC 5000 it may be installed for indoor residential and light to moderate commercial floors and countertops in dry areas only over CSA-0211 EXTERIOR SELECT or (SEL TF) Douglas Fir plywood according to COFI classification, vinyl asbestos tile and dry cut-back adhesive. For increased freeze/thaw resistance mix with DYNALASTIC 5000 in place of water. For the installation of porcelain stoneware tile DYNALASTIC 5000 should be used in place of water.

ADVANTAGES

– Easy to Handle: Plastic, workable, glides on, non-sagging, long open time and increased tile adjustability.
– High Bond Strength: Greater than 200% stronger than mastic type adhesives.
– Versatile: Lower material and labour costs than conventional Portland cement mortar beds.

USES

Ideal for setting vitreous (low absorption, less than 6%) ceramic floor tiles, quarry tiles, and pavers over concrete masonry, cured Portland cement mortar beds, brick, glass mesh mortar units, gypsum board, unglazed ceramic, marble and clay tile for residential, commercial, interior or exterior applications.

COLORS

LIMITATIONS

1. Do not use over presswood, particle board, Masonite, chipboard, laun, asbestos board, gypsum floor patching compounds, metal glass, plastic or any unstable materials which are deemed unsuitable substrates.
2. In dry areas only for interior residential, light or moderate commercial floors when mixed with DYNALASTIC 5000 in place of water it can be used on CSA-0211 Exterior Select or (SEL TF) Douglas fir plywood and countertops.
3. Do not use in temperatures below 10°C (50°F) or above 40°C (104°F).
4. Keep the area of installation from freezing for at least 28 days after application.